Cigar Prop lighter breather

Does the lighter stop working properly after the first filling?
After filling the new Jet Flame lighter, nothing works any more. And that despite the correct lighter gas. This is usually because the lighter has not been vented correctly.

And once again an American inventor has the solution: Kevin D. Shahan designed the Cigar Prop lighter breather after he was unable to find any other tool for simple venting. In many cases, the excess pressure that is still in the lighter is the reason why the Jet-Flame gives up the ghost after a few attempts at filling and can no longer be filled correctly.
The vent is massive enough to apply sufficient pressure to the valve. In addition, an outlet hole is positioned in such a way that the remaining gas can escape from the lighter easily and in a controlled manner on two sides. The vent ensures that the excess pressure can escape and the nozzles of the Jet Flame lighter can function properly again.

Characteristics

• Housing: Quality 6061 aluminium
• Tip: Brass
• Length: 6.3 cm (incl. brass tip), width: 1.3 cm
• Weight: 15 gr
• Produced 100% in the USA

How to use

1. Hold the lighter vertically downwards so that you can press the brass bleeder tip into the lighter valve from above.
2. Position the breather so that the vent holes of the lighter breather point away from you to the right and left (see picture), otherwise the gas will spray into your face.
3. Press the vent firmly onto the valve, release, press again, release and repeat until you can no longer hear any hissing
   Then fill the lighter with high-quality lighter gas according to the manufacturer's instructions.
4. Jet-Flame lighters normally need approx. 1-3 minutes after filling before they are ready for use again